Centroid CNC DIY Control Boards, great alternative to mach3, wincnc, motion control software
Plug and Play Centroid DC Servo Motor and Spindle Encoder Cable

Plug and Play Centroid DC Servo Motor and Spindle Encoder Cable

$85.00$90.00

Estimated Shipping Date

Ordered
Shipped

Choose between two stock lengths, 12 foot and 16 foot. These cables use twisted pair made-in-USA wire and are properly shielded and grounded for reliable encoder signal and are built and assembled by Centroid in the USA. (If a longer cable is required, we suggest purchasing the bulk encoder cable)

These cables are commonly used when upgrading DC servo motor encoders for use with the Allin1DC CNC controller. These cables can also be used for spindle encoder applications on both the Allin1DC and Acorn CNC controllers. One end of the cable is a DB9 connector which plugs directly into the Allin1DC or Acorn CNC controller, the other end of the cable is a single row flat pin connector (9 pin C-grid connector) which plugs into the Centroid Encoder pig tail mating connector.
A mating 9 pin C-grid connector and pins are optional with this cable for the case when a non-Centroid encoder is used. The optional mating 9 pin C-grid connector can be installed on the non-Centroid encoder pig tail wires which then allows the encoder to plug directly into this cable with no soldering or cutting of this cable.
 
 

Compatible with:
Shopping cart0
There are no products in the cart!
Continue shopping