Part, Vise and Fixture Probing: Automatically Set Zero points fast and accurate.
Use the KP-3 probe to quickly and accurately find zero points on a vise, fixture or part. Eliminate operator error when setting zero points, finding edges, or center locations of bosses or bores, slots and webs. Eliminates the need for a centerfinder or an edgefinder. You'll never have to spend 30 minutes using a center finder to locate the center of a bore again. The probe will find and set the center of a bore in just seconds. In addition the probe can be used to verify part dimensions and locations and many other applications. The KP-3 mounts in any 1/2" or 10mm tool holder and has concentric adjustment screws. Also compatible with Mach3/4, WinCNC, LinuxCNC, Pathpilot and others.
Replacement or additional probe tips can be purchased here.
KP-3 Specifications
-Probing directions X+/-, Y+/-, Z-
-Unidirectional repeatability (2 sigma) 0.00006” (1.5 micron)
-Practical use results on a good milling machine .0005”
-Probe deflection force (X,Y) 3 ounce minimum with 40mm stylus
-Probe deflection force (Z) 15 ounce minimum
-Probe body diameter and length D= 1.35” (34.3mm) L= 2.16” (54.9mm)
-Mounting shank diameter and length D= 0.5” (12.7mm) L= 1.47” (37.3mm)
-Stylus mount thread M3 thread
-Power supply required: none
-LED status indicator red when triggered (powered by input 1ma)
-Weight of probe and ½”shank 0.40 lb
-Over travel limit angle (X,Y) +/- 12 degrees from vertical
-Over travel limit (Z-) 0.25” (6.25mm)
-Environmental IP64
-Patented concentric alignment (spindle/tool holder/probe body run out adjustment)
Compatible with:
Reviews
There are no reviews yet